• APPROVED

    • Connecting LQ to RTS via 4W

    Owned by Jeremy Thelen, created
    Last updated: Jul 11, 2024 by ernie addow
    2 min read

    How to connect your LQ to an RTS system via 4-Wire.

     Instructions

    1. Confirm LAN 1 on the LQ is properly connected to your network

    2. Locate a straight through RJ-45 cable

    3. Connect one end of the RJ-45 cable to Port A on the LQ

    4. Connect the other end of of the RJ-45 cable to your matrix.

    If your intercom does not have an RJ-45 connection for 4-wire please consult the pinout diagram at the bottom to make a RJ-11 or DB9 adapter

    1. Open AZedit, navigate to Alphas → Ports.

    2. Locate the port the LQ is plugged into and change the alpha by double clicking the port

    3. Open System → keypanel assignment, select the desired panel and add the alpha. Don’t forget to add the “AF” on the listen side

    4. If there is a need for more then one channel between the LQ and your RTS system repeat steps 2-7 again using Port B on the LQ

    5. When connecting to RTS you will need to switch the talk/listen pins on the 4w LQ port

      1. Connect to the LQ CCM (Web interface)

      2. Navigate to the Device page, select ports

      3. Change the port function, “to panel”

    image-20240710-134905.png

    1. Test the audio connection

     

     

    Other: What are the RJ11 pinouts on a RTS Adam Matrix Frame?

    LQ Can i connect LQ to RTS Adam matrix