Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

Instructions

  1. Loosen the set screw on the back of the Belt Pack (BP)

  2. In early models, the screw is a #1 Phillips Head and in recent ones, a #8 TORX Head

  3. Slide the metal clip 90 degrees to expose the dip switched

  4. With a small screwdriver or a metal pick, slide switched 5, 8 and 9 to the down position

  5. Return the metal clip to the normal position and tighten the screw

 

(It is a good idea to use tape to mark that this BP is set to RTS mode in cases where it might be mixed with Clear-Com Mode BPs… or if, in a rental environment, it would need to be identified as such)

  • No labels

CAN'T FIND YOUR ANSWER? CLICK HERE TO CONTACT SUPPORT

This solution was provided to you by Clear-Com via a question submitted to us by customers like you. If your question wasn’t answered, you need help or you have a recommended solution for our database, please send us an email at support@clearcom.com

The information on this page is owned by Clear-Com and constitutes Clear-Com’s confidential and proprietary information, may be used solely for purposes related to the furtherance of Clear-Com’ business and shall not be disclosed, distributed, copied or disseminated without Clear-Com’s prior written consent. Click Here for Clear-Com's privacy statement.