Wireless: Can I use more than 1 DX100 base station in the same location?
Up to 4 DX100 base stations can be used together in the same location using BP200 beltpacks or W200 headsets.
One base station must be designated as “primary” and all others must be designated as “secondary”. You can have only one primary and up to 3 secondary base stations. Secondary base stations are assigned numbers 1, 2, or 3.
• Label the base stations as “Primary,” “1,” “2” and “3.”
• Start with every base station and Beltpack/Headset power off.
Set DIP Switches
Open each secondary base station and set DIP switch #4 to the ON position as follows.
• Remove the six screws from the front panel of each secondary base station. Lift the front panel carefully and set it face down. Be careful not to pull any wires loose.
• Locate the DIP switch on the transceiver circuit board inside the front panel of each secondary base station. Set DIP switch #4 to the ON position. Leave #s 1 and 3 in the OFF position. See picture below.
• Replace the front panel and screws on the secondary base stations.
• The primary base station DIP switch #4 should be in the OFF position.
One base station must be designated as “primary” and all others must be designated as “secondary”. You can have only one primary and up to 3 secondary base stations. Secondary base stations are assigned numbers 1, 2, or 3.
• Label the base stations as “Primary,” “1,” “2” and “3.”
• Start with every base station and Beltpack/Headset power off.
Set DIP Switches
Open each secondary base station and set DIP switch #4 to the ON position as follows.
• Remove the six screws from the front panel of each secondary base station. Lift the front panel carefully and set it face down. Be careful not to pull any wires loose.
• Locate the DIP switch on the transceiver circuit board inside the front panel of each secondary base station. Set DIP switch #4 to the ON position. Leave #s 1 and 3 in the OFF position. See picture below.
• Replace the front panel and screws on the secondary base stations.
• The primary base station DIP switch #4 should be in the OFF position.
CAN'T FIND YOUR ANSWER? CLICK HERE TO CONTACT SUPPORT
This solution was provided to you by Clear-Com via a question submitted to us by customers like you. If your question wasn’t answered, you need help or you have a recommended solution for our database, please send us an email at support@clearcom.com
The information on this page is owned by Clear-Com and constitutes Clear-Com’s confidential and proprietary information, may be used solely for purposes related to the furtherance of Clear-Com’ business and shall not be disclosed, distributed, copied or disseminated without Clear-Com’s prior written consent. Click Here for Clear-Com's privacy statement.