Is there a way of getting the mDNS Hostnames for FSII-TCVR-IPs
The mDNS Hostname is similar to computer-name (like “MY-clear-com-laptop”)
You will find the mDNS name of the FSII-TCVR-IP on the rear of the antenna
Additional information on registering your FSII-TCVR-IP to your matrix
See FSII-TCVR-IP quick start guide : FSII-TCVR-IP-QSG
With a DHCP Server
Connect FSII-TCVR-IPs and E-IPA card (LAN #3) to AES67 network switch with DHCP server enabled
We recommend that the E-IPA card LAN #3 port (Default port for AES67 connections) is given a static IP adddress
Using the Transceiver screen in EHX, add all the transceivers to the configuration via the "Detect IP TCVR" button
Once all IPTs have been ADDED do an Apply Changes
Register beltpacks to EHX as normally done
Do a full walk test
No DHCP Server
Connect 1x Antenna directly to you PC
As mentioned above, the transceiver will boot up in DHCP but switch to a link local address after a period of time
On your PC change the ethernet port to a link local address, 169.254.xxx.xxx (or DHCP mode)
Connect the IP Transceiver directly to your PC's ethernet port
In Google Chrome install/open the mDNS Browser application (downloadable from the Google Chrome App Store). Or use a IP scanning tool that shows mDNS names (like Avanced IP scanner https://www.advanced-ip-scanner.com/)
In the list you should find the IP Transceiver and the IP Address it has picked
In a new tab in Google Chrome, enter the IP Address listed in the mDNS Browser for the IP Transceiver
This will open the Clear-Com CCM hosted on the transceiver
Once logged in change both Admin and AES IP Address to the static IP addresses
BE SURE TO LABEL THE TRANSCEIVER WITH THE IP ADDRESS!
7. Repeat steps 4-6 until all transceivers have been given an IP Address
8. Now plug in all transceivers to the AES67 switch
9. In EHX, make sure you've given a static IP to the AES67 and Admin ports within the IPA card
10. Using the Transceiver screen in EHX, add all the transceivers to the configuration via the "Detect IP TCVR" button
11. Once all IPTs have been ADDED do an Apply Changes
12. Register beltpacks to EHX as normally done
13. Do a full walk test