Page Comparison

When an Iris panel is connected to 4-wire and needing to be upgraded, the easiest process is to use a USB stick and go around to each individual panel. If this isn’t possible, and a network is not available, then the next best step is to do a direct IP connection from you PC to the panel and upgrade using the panels CCM (in built web browser application). Here are the directions on how to make this happen.

1. Disconnect the Analog/4-wire cable

2. Connect the IP port of the panel to your PC directly

3. Power up the panel and get the IP address

   1. Press Local Menu

      

   2. Press IP Setup

      Image RemovedImage Added

   3. Press Net Setup

      Image RemovedImage Added

   4. Press IP Address

      Image RemovedImage Added

   5. Make note of the IP Address being displayed

      Image RemovedImage Added

4. On your PC, change the IPv4 setting for your network card to an IP address that is one off from what is displayed on the panel

   

5. In a web browser, enter the IP address of the panel that is showing on the display

   

6. The username password should be

   1. user: admin

   2. pass: Serial Number of your panel (nnllnnnn)

   3. If the serial number doesn’t work, look at the bottom right OLDED display on the Iris Panel. It should show “CC-IRIS-xxxxx” Try entering the values after “CC-IRIS-” for the password.

7. Go to Upgrade

   Image RemovedImage Added

8. Upload the file, should be a tar.gz

   solution update May 2023 : in later versions of V-Iris firmware the file format changed and may be labeled xxx.ccf

   Image RemovedImage Added

9. Click upgrade

Once the upgrade is finished, the panel will reset and go back to a scrolling screen and is ready for you to re-connect to 4-wire.

...