Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

If you see some garbage characters on the display after installing the app code using tera term and upgrading the fpga, you can try the following instructions from the service department:

There's a small button on thebackside of the module which opens a menu on the module itself.
You need to go EEPROM and set to unlock to change settings, then to
COMMS –> ASYNC –> BAUD 19200 PARITY NONE
Then go to EEPROM again and set lock.  (You may also need to select the reset option on the EEPROM)
If the menu doesn't clear on the module itself, then the module is defective. Whensettings are good and you get no clear display, something must be wrong with thedisplay output on the Pico mainboard.
We sometimes also have the problem with serially downloading the app, sometimesonly an old computer with Windows XP, S4driver (the old blue one) and a realCOM-port (no usb adaptor) helps.
Also a low battery or a wrong set battery jumper can be the reason.
It is strongly recommended that these actions be done by a representative of Clear-Com as the opening of the Pico device could lead to your warranty being voided.