Matrix: How do I connect a Telex BTR-80N wireless basestation to a Eclipse frame via 4-wire?
Question: I am looking to construct a custom cable that would allow me to connect my Telex
BTR-80N wireless intercom to a Eclipse Median matrix. I would assume that this is a direct
connection via 4-Wire ports?
Answer: Yes a 4-wire connection between these two devices is possible using 4wire ports on
each device. The BTR-80N uses an RJ-11 connector and the Eclipse frame uses an RJ-45 connector,
so you will have to construct a custom cable to make the connection. See diagram below for the wiring
pinouts for both devices using a CAT-5 patch cable with one end cut off and re-crimped with a RJ-11
connector.
In the EHX configuration setup set the BTR-80N connected port as a 4wire "Direct"
BTR-80N wireless intercom to a Eclipse Median matrix. I would assume that this is a direct
connection via 4-Wire ports?
Answer: Yes a 4-wire connection between these two devices is possible using 4wire ports on
each device. The BTR-80N uses an RJ-11 connector and the Eclipse frame uses an RJ-45 connector,
so you will have to construct a custom cable to make the connection. See diagram below for the wiring
pinouts for both devices using a CAT-5 patch cable with one end cut off and re-crimped with a RJ-11
connector.
In the EHX configuration setup set the BTR-80N connected port as a 4wire "Direct"
CAN'T FIND YOUR ANSWER? CLICK HERE TO CONTACT SUPPORT
This solution was provided to you by Clear-Com via a question submitted to us by customers like you. If your question wasn’t answered, you need help or you have a recommended solution for our database, please send us an email at support@clearcom.com
The information on this page is owned by Clear-Com and constitutes Clear-Com’s confidential and proprietary information, may be used solely for purposes related to the furtherance of Clear-Com’ business and shall not be disclosed, distributed, copied or disseminated without Clear-Com’s prior written consent. Click Here for Clear-Com's privacy statement.