Port Viewers enable you to visually monitor routing to and from a four-wire port, and also to assign entities to four-wires (sometimes known as XY routing). An entity can be a four-wire, panel, telephone, ident or monitor.
In Configure Canvas mode, you can create:
• A pre-populated Port Viewer by dragging to the canvas one of the four-wires listed under the Configure Canvas > Directs.
The target four-wire for the viewer cannot be changed.
• An unpopulated (empty) Port Viewer by dragging to the canvas the Port Viewer icon from the palette > Other tab.
To populate the viewer, drag and drop a four-wire to the viewer in Assignment mode. The target four-wire for the viewer can be changed for any other four-wire.
The Port Viewer displays:
• The conferences of which the monitored four-wire is a member.
• All the ports (panels, four-wires, idents, monitors and key groups) the monitored four-wire is connected to. Arrows are used to indicate the audio direction to / from the 4wire port 























When port viewers contain Party-lines (in picture above the PLs are labeled PL01 and PL02), any panels that are members of that party-line with show up in the port viewer with arrows pointing inwards (listens) and outwards (talks).  Any permanent port members will show up
as well.