Matrix: My ICS-22 beeps a call signal when I reset my Pico frame
Question: When I power up my Pico frame or reset my Pico frame the ICS-22 panel that is connected to it will beep a change signal / call signal tone for approximately 20 seconds or longer. Can I stop the panel from doing this on a reset?
Answer: Remove the ICS-22 from its enclosure and orientate it per the drawing below. Look for the call alert tone level control near the dip switches. With a small blade screwdriver adjust this control fully counter clockwise. This will stop the call signal tones on a frame power up or a frame reset.
Key words ECS , EHX v9.0
Answer: Remove the ICS-22 from its enclosure and orientate it per the drawing below. Look for the call alert tone level control near the dip switches. With a small blade screwdriver adjust this control fully counter clockwise. This will stop the call signal tones on a frame power up or a frame reset.
Key words ECS , EHX v9.0
CAN'T FIND YOUR ANSWER? CLICK HERE TO CONTACT SUPPORT
This solution was provided to you by Clear-Com via a question submitted to us by customers like you. If your question wasn’t answered, you need help or you have a recommended solution for our database, please send us an email at support@clearcom.com
The information on this page is owned by Clear-Com and constitutes Clear-Com’s confidential and proprietary information, may be used solely for purposes related to the furtherance of Clear-Com’ business and shall not be disclosed, distributed, copied or disseminated without Clear-Com’s prior written consent. Click Here for Clear-Com's privacy statement.