KB-702 Phoenix Connector Pin-Out

Owned by Justin Emge
Last updated: Jan 08, 2021 by SookFong Lau
1 min read

Note: This pin-out solution was created by a Clear-Com Applications Engineer from a previous commissioning. Please refer to Clear-Com’s official manual and confirm the pin-out for the third-party device before proceeding.

Option modules are installed, this jumper is not used. In TW operation, the
call signal always originates on channel A. In 4-Wire operation, the call
signal is not used.
Intercom Line Connection: The KB-702 contains a 5-terminal plug-on
connector for intercom line connection. This connector is intended to be
unplugged from the circuit board when connecting the intercom line, and
then plugged back on when the wiring is completed. The connections for
each pin are visible on the circuit board when the connector is unplugged.
The pinout of this connector is as follows:
Pin 1 --- (NC)
Pin 2 --- Channel A Audio
Pin 3 --- Channel B Audio
Pin 4 --- Power
Pin 5 --- Ground (Shield)

 

CAN'T FIND YOUR ANSWER? CLICK HERE TO CONTACT SUPPORT

This solution was provided by Clear-Com via a question submitted to us by customers like you. If you wish to share with us a new solution or update an old one, please follow this link..

The information on this page is owned by Clear-Com and constitutes Clear-Com’s confidential and proprietary information, may be used solely for purposes related to the furtherance of Clear-Com’ business and shall not be disclosed, distributed, copied or disseminated without Clear-Com’s prior written consent. Click Here for Clear-Com's privacy statement.