/
Arcadia : How do I configure in Arcadia CCM to connect to Radio

Arcadia : How do I configure in Arcadia CCM to connect to Radio

  • APPROVED

    • To connect Arcadia Station, V-Series panels,HelixNet endpoints such as the HRM-4X, to a radio linked to the IMF-102 via the FOR-22 in Arcadia, follow these steps:

     

    Connect your FOR-22 module to a 4wire port on the Arcadia

    We will use the call signal function to trigger the FOR-22 relay which will act like a PTT for the radio

    image-20250612-181456.png

     

    1. Configure the Channel: In Arcadia CCM, set up a channel and link it to a 4Wire port.

      1. Set the Arcadia 4wire port function to 4wire-X

    2. Control Logic Activation: Utilize the Control Logic to activate the call signal to the radio as illustrated below.

    image-20250514-090852.png

     

    1. Assigning to Panels: Once the call signal is activated, you can assign it to an Arcadia Station or V-Series panels or HelixNet End point HRM-4X

      image-20250514-091044.png
      image-20250514-091201.png

       

    Panels on Arcadia is only available on version v4.0 or later

     

    To assign the call signal to HelixNet HRM, follow these steps:

    1. Configure the HelixNet Remote Station with the 4-key setup to the Channel linked with the 4wire (Channel 1).

    2. Set the Secondary Talk Action to "Call," as illustrated below.

    image-20250514-102303.png

     

    CAN'T FIND YOUR ANSWER? CLICK HERE TO CONTACT SUPPORT

    This solution was provided by Clear-Com via a question submitted to us by customers like you. If you wish to share with us a new solution or update an old one, please follow this link..

    The information on this page is owned by Clear-Com and constitutes Clear-Com’s confidential and proprietary information, may be used solely for purposes related to the furtherance of Clear-Com’ business and shall not be disclosed, distributed, copied or disseminated without Clear-Com’s prior written consent. Click Here for Clear-Com's privacy statement.