Multiple Talk keys for same destinations
If you configure on a panel multiple Talk Keys for the same destination across different pages, keys are not linked and they work independently.In other words this configuration doesn’t work properly if you want to keep part of your panel configuration identical across page changes.Is there a fix for this, or it should/could be achieved differently.
Answer: There are couple of options to try 
a) You can program the same keys to be in the same interlock group on the panel (across the shift pages)Interlocking keys : user can assign several keys on a panel into a selector group and restrict the group so that only one key of the group can be activate at any one time. This function only refers to talk paths. For example if a panel had five keys programmed to talk to cameras 1 to 5 then by setting these into an interlocked group only one camera key can be selected at a time. There are nine available interlocked groups to which the EHX user can assign any or all panel keys. The interlock groups are specific to the panel they are programmed for and do not affect interlock groups that may be set up on any other panel in the system 






































Using Logic MaestroIf you need this for a very specific set of keys, you could work around it by using a non-latch control instead of the actual key to the destination. Create a Logic Maestro diagram that uses the control to toggle a flip-flop (latch) and connect the action that is supposed to happen with the Q-output of the flip flop. Then add a panel control to turn all the keys with that control RED (or whatever you had in mind).