/
Optocore: How do I enable my Optocore unit to pass Ethernet data
Optocore: How do I enable my Optocore unit to pass Ethernet data
- Administrator
Owned by Administrator
Apr 06, 2019
Question: I have my Optocore units setup to connect Clear-Com panels over fibre. I noticed that on the Optocore units there are a couple of LAN ports. Can I use these LAN ports?
Answer: Yes you can use these LAN ports. The LAN ports on the Optoroce units act like a two-port Ethernet switch, so they will carry any data you port into them. They do not provide router functions or DHCP.
There are a couple of ways to enable Ethernet:
1. While being OFFLINE go to SET/CONFIGURATION
2. Enable ETHERNET flag
3. Ensure that LOCAL ETHERNET flag is enabled on each intercom box (by enteringthe SETUP for each device)
4. Exit the CONFIGURATION dialogue by pressing OK
5. Do the ACTION/SEND ALL command - it will send the configuration to all ofthe devices connected by fibre.
or
When connected to the Optocore unit via the front USB cable Navigate to the local settings menu and enable "local Ethernet" on the units
Answer: Yes you can use these LAN ports. The LAN ports on the Optoroce units act like a two-port Ethernet switch, so they will carry any data you port into them. They do not provide router functions or DHCP.
There are a couple of ways to enable Ethernet:
1. While being OFFLINE go to SET/CONFIGURATION
2. Enable ETHERNET flag
3. Ensure that LOCAL ETHERNET flag is enabled on each intercom box (by enteringthe SETUP for each device)
4. Exit the CONFIGURATION dialogue by pressing OK
5. Do the ACTION/SEND ALL command - it will send the configuration to all ofthe devices connected by fibre.
or
When connected to the Optocore unit via the front USB cable Navigate to the local settings menu and enable "local Ethernet" on the units
, multiple selections available,
Related content
Optocore: How do I connect to Optocore interfaces?
Optocore: How do I connect to Optocore interfaces?
More like this
Optocore: How do I configure a pair of Optocore V3R-FX interfaces to support up to four Matrix to Panel connections?
Optocore: How do I configure a pair of Optocore V3R-FX interfaces to support up to four Matrix to Panel connections?
More like this
Optocore: When installing Optocore software which options should I install?
Optocore: When installing Optocore software which options should I install?
More like this
Matrix: Can I connect a 4 port V3R-FX Optocore unit to a 8 port X6R-FX Optocore unit?
Matrix: Can I connect a 4 port V3R-FX Optocore unit to a 8 port X6R-FX Optocore unit?
More like this
Matrix: How do I assign ID numbers to a pair of X6R-FX 8 port intercom interfaces?
Matrix: How do I assign ID numbers to a pair of X6R-FX 8 port intercom interfaces?
More like this
Matrix: What type of fiber cable / connector is needed for the Optocore X6R-FX and V3R-FX fiber interfaces?
Matrix: What type of fiber cable / connector is needed for the Optocore X6R-FX and V3R-FX fiber interfaces?
More like this
CAN'T FIND YOUR ANSWER? CLICK HERE TO CONTACT SUPPORT
This solution was provided by Clear-Com via a question submitted to us by customers like you. If you wish to share with us a new solution or update an old one, please follow this link..
The information on this page is owned by Clear-Com and constitutes Clear-Com’s confidential and proprietary information, may be used solely for purposes related to the furtherance of Clear-Com’ business and shall not be disclosed, distributed, copied or disseminated without Clear-Com’s prior written consent. Click Here for Clear-Com's privacy statement.