Partyline : What is the specification for Call Signal on a Clear-Com Partyline system
To generate the call light signal on a Partyline system, you need a to place a DC voltage on Pin 3.
Clear Com Partyline XLR pin-out
Pin 1 = Gnd
Pin 2 = Supply Voltage +30V DC
Pin 3 = Audio/+15V DC call light
Note : RTS call signal uses 20Khz out of band tone
, multiple selections available,
Related content
General: What is the difference between an XLR connector wired for balanced audio and one wired for Clear-Com partyline intercom?
General: What is the difference between an XLR connector wired for balanced audio and one wired for Clear-Com partyline intercom?
More like this
Encore Partyline Solutions
Encore Partyline Solutions
More like this
Partyline: Can I connect Encore Partyline product over CAT5 cable
Partyline: Can I connect Encore Partyline product over CAT5 cable
More like this
Clear-Com Devices
Clear-Com Devices
More like this
Clear-Com to Riedel 4-Wire
Clear-Com to Riedel 4-Wire
More like this
Clear-Com Solution Finder Home
Clear-Com Solution Finder Home
More like this
CAN'T FIND YOUR ANSWER? CLICK HERE TO CONTACT SUPPORT
This solution was provided by Clear-Com via a question submitted to us by customers like you. If you wish to share with us a new solution or update an old one, please follow this link..
The information on this page is owned by Clear-Com and constitutes Clear-Com’s confidential and proprietary information, may be used solely for purposes related to the furtherance of Clear-Com’ business and shall not be disclosed, distributed, copied or disseminated without Clear-Com’s prior written consent. Click Here for Clear-Com's privacy statement.