/
Partyline: Wiring up a PT-4 / PT-7 Microphone to a 4-pin XLR Female connector

Partyline: Wiring up a PT-4 / PT-7 Microphone to a 4-pin XLR Female connector

Owned by Administrator
Last updated: May 28, 2023 by ernie addow
1 min read

Question:  I have a PT-7 microphone that the XLR connector was accidentally cut off, now I need to rewire it to a new 4-pin XLR connector, can you supply the correct wiring for the connector?


Answer:  The wiring for the PT-7 microphone is provided below, note that the connector also requires two resistors to be wired to the XLR connector: 
(1) 220 ohm resistor between XLR pins 1 and 2
(1) 2.2k ohm resistor between XLR pins 3 and 4

Note:  This wiring scheme also applies to the discontinued PT-4 microphone.












Related content

CAN'T FIND YOUR ANSWER? CLICK HERE TO CONTACT SUPPORT

This solution was provided by Clear-Com via a question submitted to us by customers like you. If you wish to share with us a new solution or update an old one, please follow this link..

The information on this page is owned by Clear-Com and constitutes Clear-Com’s confidential and proprietary information, may be used solely for purposes related to the furtherance of Clear-Com’ business and shall not be disclosed, distributed, copied or disseminated without Clear-Com’s prior written consent. Click Here for Clear-Com's privacy statement.