Matrix: How can i connect 3 Tempest Roaming systems to Eclipse matrix
I'm trying to setup aroaming wireless solution with tempest 2400 units.
I'm planning to have the following scenario;
I have a Median matrix, 3 tempest 2400 and several wireless belt packs to beinstalled into 3 tv studios where a roaming domain would be implemented andwireless belt packs should be accessible at each studio with same id.
I examined the Hope Community Church solution, but I need to clarify theintegration between median and tempest.
My current planning is to connect ch1 and ch2 to median 4-wire ports on firsttempest then loop this port to 2nd and 3rd tempest via 2-wire I/Os.
If tempest is performing 4-wire input to 2-wire output looping, this shouldwork which gives me 2 roaming user on 3 tempest coverage configured as a singledomain. I'll connect the ch3 and ch4 on all tempest units to separate median 4wire ports so I'll have 2 non roaming wireless user at each studio.
I wonder if this scenario would work to integrate tempest units and medianmatrix with a single roaming domain.
Or should I connect the ch1 and ch2 on first tempest to 2-wire ports on medianmatrix?
Or should I consider a totally different approach?
If you can give me a clue on this configuration I'll finalize the wiring andthe configurations accordingly.
Withregard to your question there are two options a)set Chnls 1 and Chnl 2 of the Tempest basetations to 2wire mode connectthe basestations together via the loop through XLRs and also connected them tothe CCI-22 on the matrix Thiswill allow the audio from chnl 1 and 2 to be shared between the basestationsand also with the intercom panel users Chnl 3 and 4 of the tempest basestations canbe wired direct to the matrix so that the intercoms panels can talk to eachstudio directly
b)set Chnls 1 and Chnl 2 of the Tempest basetations to 4wire mode and wire themdirectly to the matrix UsingEHX configure chnl 1 from each base into matrix partyline 1 UsingEHX confg chnl 2 from each base into matrix partyline 2Thiswill allow the audio from chnl 1 and 2 to be shared between the basestationsand also with the intercom panel users UsingEHX assign keys on the panels to talk to partyline 1 or 2 Chnl3 and 4 of the tempest basestations can be wired direct to the matrix so thatthe intercoms panels can talk to each studio directly
See attached drawing