Matrix: E-Dante card auto alias label populating from Dante Controller

Matrix: E-Dante card auto alias label populating from Dante Controller

Within the Dante network, Dante enabled devices and associated audio channels are identified by names (labels).
This contributes to an interface that is easy to read and use. When interfacing an Eclipse system with Dante, you
can show the Dante channel names on ports using Auto Alias Updates. This makes redirecting or re configuring
any networked audio set up much faster and easier.
Chose from three different Auto Alias Update options:

image-20260520-140237.png

Set Auto Alias Updates to show Dante channel names
*In the EHX software, navigate to Cards and Ports > E-DANTE64 > Port > Port Properties > Basic Options > Auto Alias Updates.
*Click the small arrow on the right to access drop-down menu and select required option.
*Click Apply Changes to Matrix.

 

Rx Channel label - will show the E-Dante card port RECEIVER channel / port name - when changed using Dante controller
Source Tx Channel label - will show the Dante TRANSMITTER channel / port name - when it makes a route (xpt) to your E-Dante card - when changed using Dante controller

Note:
Auto Alias Updates only works on ports configured as Directs, Trunk labels will not show Dante labels.
Labels in EHX contain a maximum of 10 characters. Dante labels can use up to 30 characters, so only the first 10 characters of the Dante label will be shown in Eclipse.
If a port has a split label then only the listen and forced listen labels are overwritten by the alias.

 

The Eclipse system only shows the alias label changes ONCE an active xpt is made in the Dante controller , with the E-dante card as a receiver

!!making an xpt to it self will not change the labels even though the Dante controller has made the route the xpt must from a different Dante device (3rd party or 2nd E-Dante card)!!


 

Eclipse PANEL with Dante ports configured

image-20260520-140818.png

 

E-Dante port D01 is set to RX channel label alias

image-20260520-141407.png

 

 

E-Dante port D02 is set to source TX channel label alias

image-20260520-141335.png

 

In Dante controller change the channel label

Select DEVICE > RECEIVE or TRANSIT channel and edit the channel label

i.e change the RX channel labels on the E-Dante

image-20260520-141614.png

 

Select DEVICE > RECEIVE or TRANSIT channel and edit the channel label

i.e change the Source TX channel labels on the 3rd party Dante virtual sound card

image-20260520-141849.png

 

make routes to the E-dante (E-Dante is set as receiver)

image-20260520-142014.png

 

Eclipse Panel shows now shows the alias labels

D01 port renamed as CC-ERIK (because it is set to show RX channel alias)

D02 port renamed as DV-PROD1 (because it is set to show Source TX channel alias)

The Eclipse system only shows the alias label changes ONCE an active xpt is made in the Dante controller , with the E-dante card as a receiver

!!making an xpt to it self will not change the labels even though the Dante controller has made the route the xpt must from a different Dante device (3rd party or 2nd E-Dante card)!!

image-20260520-142050.png

 

CAN'T FIND YOUR ANSWER? CLICK HERE TO CONTACT SUPPORT


This solution was provided by Clear-Com via a question submitted to us by customers like you. If you wish to share with us a new solution or update an old one, please follow this link..


The information on this page is owned by Clear-Com and constitutes Clear-Com’s confidential and proprietary information, may be used solely for purposes related to the furtherance of Clear-Com’ business and shall not be disclosed, distributed, copied or disseminated without Clear-Com’s prior written consent. Click Here for Clear-Com's privacy statement.