Matrix: Mentor RG settings when used as a AES67 grandmaster clock
Please see the Mentor RG user manual for full details. https://www.trilogycomms.com/en/assets/uploads/user-guides/assets/uploads/Mentor_RG_UserGuide_36090600.pdf( https://www.trilogycomms.com/en/support/user-guides )
Depending on your AES67 setup you might have to adjust some settings (see attached)
Mentor RG units curently (dated 2018) use 100Mb NICs, please ensure your Ethernet switch supports 100Mb connections
The settings below have been tested on a Clear-Com AES67 network with our IP transceivers and E-IPA card
.note: The priority1 and priority2 parameters, it should be set to anything below 127 (which is the priority advertised by the E-IPA card) if you want the Mentor to be the grandmaster clock. Does not necessarily need to be set to 64.
Generic PTP grandmaster clock settings
Parameter Proposed Value Comment Domain 0 Announce Interval 1 2 seconds Announce Receipt Timeout 3 Sync Interval -3 0.125 second Min Delay Request Interval 0 1 second