When I re-register a Freespeak II beltpack to a base station that it was previously registered to what messages should I see on the beltpack LCD screen?  This applies to a beltpack that was un-registered via the beltpack System Connect menu. 
*Power up the FS II beltpack, the initial screen message will say "Searching....." or "No Connection"  after a period of time.
*Press the BP menu button and scroll to the System Connect menu, then press the "D" button
*The Beltpack will look for any FS II base stations that have transceiver antennas broadcasting RF signals.  The beltpack screen will display the System Name of the base on the display.  Scroll to highlight the System name and press the "D" button
*The BP will display "NOT OPEN FOR REGISTRATION".  This indicates the base station is not in pairing mode
*Place the base station in over the air REGISTRATION mode via the front panel or via the configuration editor software
*Access the BP System Connect menu again, the display will show the base station System name and a V P - characters which indicates the System is Visible and in Pairing mode
*Press the "D" button, the beltpack LCD screen will say Searching... then say Connecting to System Name XXXXXXXX and then the beltpack will go online to its previously selected role