/
Wireless: My BP850 beltpac is not communicating what should I check?
Wireless: My BP850 beltpac is not communicating what should I check?
By Administrator
Apr 06, 2019
a) Be certain the Beltpac has fresh batteries installed, is turned on and is within range of the base station. b) Verify that the Beltpac receiver frequencies, RX1 and RX2 are set to the corresponding base transmit frequencies. Beltpac RX1 should always be set to base TX1 frequency unless TX1 is disabled or not present. Likewise, RX2 should always be set to base TX2 frequency unless TX2 is disabled or not present. c) Check the Beltpac transmit frequency and be certain that one receiver on the base is tuned to that frequency and is enabled. d) Be certain that the Beltpac is not to close to the base receive antenna. The base receiver may be overloaded if a Beltpac operating at full power is too close.
, multiple selections available,
Related content
Wireless: LED indicators on the BP850 beltpac are not acting correctly
Wireless: LED indicators on the BP850 beltpac are not acting correctly
More like this
Wireless: I have two new BP210 wireless beltpacks and can hear but can not talk.
Wireless: I have two new BP210 wireless beltpacks and can hear but can not talk.
More like this
Wireless: Not all beltpac buttons are working.
Wireless: Not all beltpac buttons are working.
More like this
Wireless: When trying to register a beltpac/headset, you hear “registration failed”
Wireless: When trying to register a beltpac/headset, you hear “registration failed”
More like this
Wireless: HME Pro850 BP850 beltpack starts cutting out if we get much further than 30 or 40 feet.
Wireless: HME Pro850 BP850 beltpack starts cutting out if we get much further than 30 or 40 feet.
More like this
Wireless: When using two (2) PRO850s (Master+Slave) together, do all eight (8) beltpacs need to be addressed from the same configuration window, or are they broken up (4 and 4)?
Wireless: When using two (2) PRO850s (Master+Slave) together, do all eight (8) beltpacs need to be addressed from the same configuration window, or are they broken up (4 and 4)?
More like this
CAN'T FIND YOUR ANSWER? CLICK HERE TO CONTACT SUPPORT
This solution was provided by Clear-Com via a question submitted to us by customers like you. If you wish to share with us a new solution or update an old one, please follow this link..
The information on this page is owned by Clear-Com and constitutes Clear-Com’s confidential and proprietary information, may be used solely for purposes related to the furtherance of Clear-Com’ business and shall not be disclosed, distributed, copied or disseminated without Clear-Com’s prior written consent. Click Here for Clear-Com's privacy statement.