Partyline: How do I setup a pair of EF-701M interfaces for fiber modems?

Partyline: How do I setup a pair of EF-701M interfaces for fiber modems?

Question:  I want to connect separate Encore party-line systems together via fiber modems.  How do I setup the EF-701M interfaces to accomplish this?
Answer:  The two switches on the rear panel of the EF-701M work independently of each other.  Switch 1 adjusts the EF-701M’s connector settings for use with either 4-wire fiber (the OFF position) or a matrix intercom (the ON position).
Switch 2 adjusts the EF-701M’s connector intercom levels for use with either Clear-Com equipment (the OFF position) or RTS-TW equipment (the ON position). Table 1-1 summarizes the mode switch settings (see table 1-1 below). 
Note:  Use the DB-15 connector pin outs for the connection to the fiber modem. 








EF-701M rear panel showing the position of the mode switches for Matrix / Direct and Clear-Com / TW operation. 
If you want to connect Encore PL systems together then set both EF-701M units to have switch #1 OFFswitch #2 OFF
Note:  Both EF-701M units will need to powered by the Partyline system they are connected to 
















CAN'T FIND YOUR ANSWER? CLICK HERE TO CONTACT SUPPORT


This solution was provided by Clear-Com via a question submitted to us by customers like you. If you wish to share with us a new solution or update an old one, please follow this link..


The information on this page is owned by Clear-Com and constitutes Clear-Com’s confidential and proprietary information, may be used solely for purposes related to the furtherance of Clear-Com’ business and shall not be disclosed, distributed, copied or disseminated without Clear-Com’s prior written consent. Click Here for Clear-Com's privacy statement.