Matrix: Is it possible to disable the headset detect on the V-series panel
Question- Would it be possible to use a V-series panel with a CC-95 connected for the listening, and at the same time use the gooseneck microphone for talking?
Answer - Yes you can disable the auto-headset detect function. There are dip switches inside the panel
HEADSET AUTO DETECT : V-Series panels can auto detect when a headset is plugged in and automatically enable them. Headset auto detect can be set to enabled or disabled via a DIP switch (SW2) on the main board. As headset insertion can cause a noise on the panel some users may wish to disable automatic headset detect and use the front panel button instead to enable and disable the headsets. To access the DIP switch the rear cover must be removed from the panel. The DIP switch is located on the righthand edge of the main PCB (looking from the rear) behind the headset connector
On =auto-switch h/set mode detect enabled
OFF=auto-switch h/set mode detect DISABLED
Related content
CAN'T FIND YOUR ANSWER? CLICK HERE TO CONTACT SUPPORT
This solution was provided by Clear-Com via a question submitted to us by customers like you. If you wish to share with us a new solution or update an old one, please follow this link..
The information on this page is owned by Clear-Com and constitutes Clear-Com’s confidential and proprietary information, may be used solely for purposes related to the furtherance of Clear-Com’ business and shall not be disclosed, distributed, copied or disseminated without Clear-Com’s prior written consent. Click Here for Clear-Com's privacy statement.