/
HelixNet: Can I wire a Sony CCU-D50 camera control unit to HelixNet via 4-wire?

HelixNet: Can I wire a Sony CCU-D50 camera control unit to HelixNet via 4-wire?

By Administrator
Apr 27, 2020

The diagram below shows the wiring between a HelixNet 4W HLI-4W2 module and a Sony CCU-D50 camera control unit using a standard CAT-5 patch cable connected to the HelixNet 4-wire module.  The other end of the CAT-5 cable is wired to the CCU via its DB-15 connector marked INTERCOM / TALLY / AUX. 
Use the green and blue pairs (audio pairs) only to connect to the CCU DB-15 connector.
Set the CCU front panel intercom dip switches to 4-wire mode while the unit is powered off. 
Note:  A PDF of this solution is attached below.










HelixNet 4W module                                                                                                                            Sony CCU-D50 Camera Control Unit























  File Modified

PDF File 2780_SONY CCU-D50 to helixnet 4w.pdf SONY CCU-D50 to helixnet 4w.pdf

Apr 06, 2019 by Administrator

PDF File 4763_helixnet 4w to CCU-D50.pdf helixnet 4w to CCU-D50.pdf

Apr 06, 2019 by Administrator

PDF File helixnet 4w to CCU-D50.pdf helixnet 4w to CCU-D50.pdf

Apr 06, 2019 by Administrator

PNG File image2020-4-27_16-17-30.png

Apr 27, 2020 by Justin Emge

PDF File SONY CCU-D50 to helixnet 4w.pdf SONY CCU-D50 to helixnet 4w.pdf

Apr 06, 2019 by Administrator

Related content

CAN'T FIND YOUR ANSWER? CLICK HERE TO CONTACT SUPPORT

This solution was provided by Clear-Com via a question submitted to us by customers like you. If you wish to share with us a new solution or update an old one, please follow this link..

The information on this page is owned by Clear-Com and constitutes Clear-Com’s confidential and proprietary information, may be used solely for purposes related to the furtherance of Clear-Com’ business and shall not be disclosed, distributed, copied or disseminated without Clear-Com’s prior written consent. Click Here for Clear-Com's privacy statement.