Matrix: JVC / Kenwood UHF basestation wired to a Eclipse Matrix

Matrix: JVC / Kenwood UHF basestation wired to a Eclipse Matrix

I have a JVC / Kenwood UHF basestation with 4wire in/out connected to a Eclipse matrix, is there anything  special i need to do for the setup
Answer: There is nothing special that you have to do on the Eclipse side. The basestation is treated as simple 4wire port (direct) in the ECS configuration system We have found that its best to set the matrix output port level between -8db... -10db so that you do not over drive the basestation. The matrix input level can be left at 0db
Remember that you need one basestation per RF chnl and each basestation takes one port on the matrix. 
If you are using the basestation in PTT mode , then you will need to trigger a matrix relay or a FOR-22 relay when ever someone on a Clear-Com panel presses a talk key to the RF chnl (basestation) in PTT mode we recommend you set the matrix port that is connected to the basestation to have "global latch disable" set so that its not permanently keyed on.

CAN'T FIND YOUR ANSWER? CLICK HERE TO CONTACT SUPPORT


This solution was provided by Clear-Com via a question submitted to us by customers like you. If you wish to share with us a new solution or update an old one, please follow this link..


The information on this page is owned by Clear-Com and constitutes Clear-Com’s confidential and proprietary information, may be used solely for purposes related to the furtherance of Clear-Com’ business and shall not be disclosed, distributed, copied or disseminated without Clear-Com’s prior written consent. Click Here for Clear-Com's privacy statement.