Wireless: Can I change the UPX-10 IFB Tx to connect to RTS or Balanced Inputs?
Connect the system's audio source to the XLR connector located on the rear panel.Verify which type of connection is to be used (Clear-Com 2-wire PL, RTS 2-wire PLor dry Balanced Audio input) If this is a balanced, transformer-isolated input, which is dc isolated to 50 volts. For thestandard mic-or line-level input modes, the pin assignments on this connector are: pin1: shield, pin 2: audio positive, pin 3: audio negative. When internally programmed for use with a Clear-Com or RTS intercom, the pinassignments will be consistent with that required by the intercom system. Theprogramming jumpers are located inside the unit at the rear of the PCB, near the XLRconnector. Programming is as follows on chart below:
The UPX-10 user manual is attached below.
The UPX-10 user manual is attached below.
CAN'T FIND YOUR ANSWER? CLICK HERE TO CONTACT SUPPORT
This solution was provided to you by Clear-Com via a question submitted to us by customers like you. If your question wasn’t answered, you need help or you have a recommended solution for our database, please send us an email at support@clearcom.com
The information on this page is owned by Clear-Com and constitutes Clear-Com’s confidential and proprietary information, may be used solely for purposes related to the furtherance of Clear-Com’ business and shall not be disclosed, distributed, copied or disseminated without Clear-Com’s prior written consent. Click Here for Clear-Com's privacy statement.