/
Matrix: Wiring a Panasonic AG-BS300 camera CCU to a 4-wire port on a Eclipse Pico frame

Matrix: Wiring a Panasonic AG-BS300 camera CCU to a 4-wire port on a Eclipse Pico frame

Dec 24, 2021

The diagram below shows how to connect a Panasonic AG-BS300 camera CCU via 4-wire connection to a Matrix Pico/ Median or Omega frame. 
Note that the camera CCU rear panel INCOM 4-wire / RTS switch should be set to 4-wire mode.  In order to connect these two devices together a custom cable will need to be made using a shielded CAT-5 cable with one end cut off and wired to a DB-9M connector. 




Note:  The use of a BAL-8 transformer interface at the Eclipse frame may be required in some cases to reduce any potential hum / noise issues on the CCU line

CAN'T FIND YOUR ANSWER? CLICK HERE TO CONTACT SUPPORT

This solution was provided by Clear-Com via a question submitted to us by customers like you. If you wish to share with us a new solution or update an old one, please follow this link..

The information on this page is owned by Clear-Com and constitutes Clear-Com’s confidential and proprietary information, may be used solely for purposes related to the furtherance of Clear-Com’ business and shall not be disclosed, distributed, copied or disseminated without Clear-Com’s prior written consent. Click Here for Clear-Com's privacy statement.