Question:  How do I wire up the logic inputs on the V-Series panel via the rear panel DB-25 connector to be activated via a remote panel switch or foot switch?  How many logic inputs can I access on a V-Series panel?

Answer:  The chart below will show the logic input 1 and 2 wiring to a panel switch or foot switch to rear panel DB-25F GPIO connector on the V-Panel. 

• Logic Inputs 1 and 2 are programmable via ECS / EHX software control,

• Logic input 3 is hardwired to trigger the "REPLY" key on the V-Panel

• Logic input 4 will activate "EXIT SUPERVISOR MODE"
  Note:  This solution is also attached as a PDF document below.