...
Disconnect the Analog/4-wire cable
Connect the IP port of the panel to your PC directly
Power up the panel and get the IP address
Press Local Menu
Press IP Setup
Press Net Setup
Press IP Address
Make note of the IP Address being displayed
On your PC, change the IPv4 setting for your network card to an IP address that is one off from what is displayed on the panel
In a web browser, enter the IP address of the panel that is showing on the display
The username password should be
user: admin
pass: Serial Number of your panel (nnllnnnn)
If the serial number doesn’t work, look at the bottom right screen of the Iris Panel. It should show “CC-IRIS-xxxxx” Try entering the values after “CC-IRIS-” for the password.
Go to Upgrade
Upload the file, should be a tar.gz
Click upgrade
Once the upgrade is finished, the panel will reset and go back to a scrolling screen and is ready for you to re-connect to 4-wire.
...