...
b. Ensure that the line HCI 1:0 is present: Hardware ID XXXXX: fspk ULDynam-EC 1 AgentIC users 32 (ver 0) HCI 1:0 type 3a
...
2) Open the Clone Ports tool (https://www.dropbox.com/s/sopnq72mfjzcdij/RecordingTest.exe?dl=0)
...
a. The IP Address should be set to the LAN1 IP of the CPU card
...
a. If this is successful, the Event Log will show something like: Req by HCI for dest mon of MyPanel by MyRecorder (PO successful)
...
b. Use the Crosspoint Map to verify that audio going to the source also shows up at the duplicate port. If “Include source audio at duplicate” was checked, you should see a permanent crosspoint from source to duplication port.
...
a. If this is successful, the Event Log will show something like: Req by HCI for dest mon of MyPanel by MyRecorder (PO cancelled)
...
b. This may need to be pressed multiple times if multiple Adds were previously performed – verify using the Crosspoint Map
...